Posted on December 17, 2018

DI251 DRIVER

Remove one screw and the lamp holder at the front. The benefits of multifunctionality – copying, printing, faxing, scanning and e-mailing- do not come at the expense of performance. Tighten the Shoulder Screws until there is no clearance between the hinges and the copier body. Remove the Image Transfer Roller Assy. Page 8 Label inside copy machine The following laser safety label will be attached inside the copy machine as shown below. Use the screw which has been removed in step 3 for A. Configuration Technical Memo Enter the serial number and other data.

Uploader: Kazill
Date Added: 28 June 2013
File Size: 48.81 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 85602
Price: Free* [*Free Regsitration Required]

Safety Precautions for Inspection and Service When performing inspection and service procedures, observe the following precautions to prevent accidents and ensure utmost safety.

Snap off one retaining ring E type and remove the gear assy, gear, and spring.

Konica Minolta DiALTA Di Copier A3 Multifunction Printer

Wipe clean the Lens with a soft cloth. Set the finisher with the main unit by inserting one end of the pipe that was used in STEP 2 into the side of the main unit where dl251 feeder attachment is installed. NOTE Support the duplex unit by hand until it is secured.

New Drivers  CANON PCL5E5C PRINTER DRIVER DOWNLOAD

Setup instructions this manual Press the stop key and then immediately press the start key. Loosen five screws of the drawer. Remove the tape from the job tray unit.

Toner for Konica Minolta DI 251

Original Size Detection Timing Depending on the model, some of the precautions given in the following do not apply. Right Fusing Roller 2. Page 79 Handling of PWBs 1. Fit the hook end of the cable into the groove in the Cable Guide and hook the spring. Verify the following accessories are in the accessory box.

Copy Job Recall Permits programming of various functions, including copying jobs.

Open the Finisher Cover. PC Drum is dirty. Wind the bead end of the cable four turns clock- Cable on wise from the rear to di2511 front.

T Blank Streaks or Bands Page 95 Attaching the paper feed unit to dii251 copy table 1. Please read the following for your own protection. Remove three screws and the Fusing Front Cover.

New Drivers  FY1327 DRIVER

Call me about this Printer. Remove the harness from six cord clamps, six wiring saddles, and two edge covers. Printer Minolta Di User Manual pages.

Scanner Motor M10 2. User Management Permits setting of the various User Management functions. Cover is opened and closed. Select the position where the ri251 feed unit is set. Page Loosen the two screws of the drawer.

Konica Minolta Di/DiF Drum Unit (OEM) 62, Pages

Lock the Paper Lifting Plate. Black Image is read at the specified density. Paper Exit Roller 6. Side Cover is opened and closed.

Now, wipe the surface of the PC Drum in one con- tinuous movement from its rear edge to vi251 front edge and off its surface one to two times.